www.rainforestautomation.com
EMU-2™
User Manual
EMU-2™ Configuration Screens
Restart
The Restart screen allows you to perform a
device restart by pressing the Top Button.
This will reboot your EMU-2™ without
losing the connection to the smart meter.
To access this screen, press both buttons
simultaneously, then release.
Pressing the Bottom Button sends you to
the Select Language screen.
Select Language
The Select Language screen is used to
change the language displayed by your
EMU-2™. This screen can only be
accessed in Configuration Mode, after
going through the Restart screen. To
enter Configuration Mode, press and
release both buttons simultaneously. Then
press the Bottom Button to get to the
Select Language screen. The currently
selected language will have an arrow
beside it. Press the Top Button to cycle between the different languages. Press the
Bottom Button to save the selected language. You will then be sent to the Set Rate
screen.
Set Rate
The Set Rate screen allows you to
manually set the current price for electricity
in cents per kWh. This screen can only be
accessed in Configuration Mode, after
going through the Restart and Select
Language screens. The price shown will
zero, unless it has been previously set in
this screen. The rightmost digit of the price
Set Rate
000.00¢/kWh Change
Keep
Select Language
English Select
Español
Français Accept
To Next Page
Loading...