Need help?Do you have a question about the RainWise MKIII-MB and is the answer not in the manual?
General| Brand | RainWise |
|---|---|
| Model | MKIII-MB |
| Category | Weather Station |
| Language | English |
Consider site obstructions, local topography, and proximity to heat sources. Sensor assembly should be clear of obstructions.
Mount sensor assembly on roof edge, 2.5 ft above roofline, on prevailing wind side. Avoid heat sources like chimneys or vents.
Supports Modbus RTU commands, 9600/19200 baud rates, and 4X Holding registers. Stations are read-only for data access.
Modify Modbus device address using dip switches 1 & 2. Default address is 60 (Switch 1=0, Switch 2=0).
Set baud rate to 9600 (default, OFF) or 19200 (ON) by changing dip switch 5.
To Next Page
