EasyManua.ls Logo

Ram Mounts TOUGH-TRAY - User Manual

Ram Mounts TOUGH-TRAY
2 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Safety Precaution
Do not install this product near or over an airbag deployment area or in a location that obstructs the driver’s vision or interferes with vehicle
operation. National Products, Inc does not assume responsibility or liability for any such personal injury, death or property damage.
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.To see more mounting options, visit rammount.com
Parts Index
not to scale
rammount.com
1.800.497.7479
support@rammount.com
RAM
®
Tough-Tray
Locking Kit
Locate and remove screw on the tray housing supporting
the spring.
4
I
J
E
Pull the Main Tray Slide out and attach (E) flange using (J) screws and (I) nuts.
RAM
®
logo must face upright.
3
AG
F
N
C
Slide (F), (N) and (C) onto rod as shown below.
2
A
G
Thread (G) nut onto (A) rod with 3/8” of the rod protruding.
1
E
A
x 1
B
x 1
F G
N
J
K
O
IH
L
M
C
x 1
P
x 1x 1
#8
x 2
#12
x 1
1/4”
x 1
#8-32 x 3/8”
x 1 x 1
1/4”-20
x 1
#8-32
x 4
#8-32
x 2
x 4
#8-32 x 1/2”
x 1
#8-32 x 1 1/2”
Continue on back

Other manuals for Ram Mounts TOUGH-TRAY

Question and Answer IconNeed help?

Do you have a question about the Ram Mounts TOUGH-TRAY and is the answer not in the manual?

Summary

Parts Index and Assembly Instructions

Thread nut onto rod

Attach nut G to rod A, ensuring 3/8 inch protrusion.

Slide components onto rod

Slide components F, N, and C onto the rod as illustrated.

Attach flange to tray slide

Attach flange E to Main Tray Slide using screws J and nuts I, with RAM logo facing up.

Remove spring housing screw

Find and remove the screw on the spring-supporting tray housing.

Insert screw and align tray slide

Insert screw L, align Tray Slide, and pull spring end over screw.

Pull and wedge tray slide

Extend Tray Slide and secure with wedge as depicted.

Secure tube with washer and nut

Place washer on screw L, feed tube B through housing, and secure with nut H.

Insert threaded rod assembly

Insert Threaded Rod Assembly into tube B, adjusting wedges F if necessary.

Close tray slide with rod assembly

Feed rod assembly through flange E, attach knob P, and secure with washer O and screw K.

Safety Precaution

Ram Mounts TOUGH-TRAY Specifications

General IconGeneral
BrandRam Mounts
ModelTOUGH-TRAY
CategoryAutomobile Accessories
LanguageEnglish

Related product manuals