RAM 1500 2014 - Page 25

4. Attach the hook to the outboard tether strap loop (see diagram). Tighten the tether
strap according to the child seat manufacturer’s instructions.
Installing Three Child Restraints:
1.
Place a child restraint on each out-
board rear seat. Route the tether straps
following the directions for right and
left seating positions, above.
2. Attach both hooks to the center tether
strap loop, but do not tighten the straps
yet.
3. Place a child restraint on the center
rear seat. Route the tether strap follow-
ing the directions for the center seating
position, above.
4. Attach the hook to the outboard tether
strap loop.
5. Tighten the tether straps according to the child seat manufacturer’s instructions,
tightening the right and left tether straps before the center tether strap.
Tether Strap Through Center Tether Strap
Loop And Attached To Outboard Tether
Strap Loop
Left Outboard And Center Seating Position
Shown
GETTING STARTED
23