Uconnect® 5.0
Clock Setting
1. To start the clock setting procedure, perform either of the following:
• Press the MORE hard-key on the right side of the display, next press the “Time”
soft-key and then press the “Set” soft-key.
• Press the SETTINGS hard-key on the right side of the display, then press the
“Clock” soft-key. The Time setting screen is displayed and the clock can be
adjusted as described in the following procedure.
NOTE:
In the Clock Setting Menu you can also select Display Clock. Display Clock turns the
clock display in the status bar on or off.
2. Touch the “Up” or “Down” arrows to adjust the hours or minutes, next select the
“AM” or “PM” soft-key. You can also select 12hr or 24hr format by touching the
desired soft-key.
3. Once the time is set press the “Done” soft-key to exit the time screen.
ELECTRONICS
70
To Next Page
Loading...
