GETTING TO KNOW YOUR VEHICLE 89
Locking Tab
6. Disconnect the wiring harness by pushing on
the two release tabs, ensuring the connector
bracket does not fall into the sill.
Connected Wiring Harness
Disconnected Body Side Harness
7. Connect the body side plug (provided in the
glove compartment) to the body side wiring
harness and insert the bracket back into
the sill.
Body Side Plug (One Piece)
8. Connect the tailgate plugs (provided in the
glove compartment) to the tailgate wiring
harness to ensure that the terminals do not
corrode.
Tailgate Plugs (Two Pieces)
9. Tape the tailgate harness and bracket against
the forward-facing surface of the tailgate. This
will prevent damaging the connector and
bracket when storing or reinstalling the
tailgate.
1 — First Release Tab
2 — Second Release Tab
1 — Large Plug
2 — Small Plug
2
22_DT_OM_EN_USC_t.book Page 89
To Next Page
Loading...
