WARRANTY
Kismet is covered by a limited five-year warranty, detailed below. Regardless of Warran-
ty status, please do not attempt to repair or modify Kismet without first contacting
support@ramblefx.com.
Ramble FX warrants, only to the original purchaser, under normal use and service, that this product is free of defects
in components and workmanship for a period of five (5) years. In the rare event of a malfunction, we will repair, or
at our option, replace this product at no charge except for shipping. Prior authorization is required by contacting
Ramble FX at support@ramblefx.com. Excluded from this warranty are cosmetic damages such as knobs, finish,
and labels. This warranty shall be null and void if the product is subjected to repair work or alteration by a person
or facility other than Ramble FX; misuse, abuse, operation with incorrect voltage, incorrect connections, wrong
accessories, and exposure to inclement conditions; shipping accidents. Ramble FX shall not be responsible for any
incidental or consequential damages. Ramble FX’s responsibility is limited to the value of the product itself. Ramble
FX assumes no responsibility for any indirect costs or losses however incurred.
RETURN POLICY
If this product was purchased directly from Ramble FX, the original owner may return it
within two weeks of receiving it for a full refund, minus all shipping costs. It must be
returned in new condition, and the buyer is responsible for return shipping. If it is
returned with any signs of wear, a restocking fee of 20% may occur. Please contact
support@ramblefx.com to initiate a return.
The information contained in this User Guide is subject to change without notice. Revisions or
additions to this document are available at www.ramblefx.com.
25
26
SPECIFICATIONS
SPECIFICATIONS
INPUT IMPEDANCE ~1M
OUTPUT IMPEDANCE ~1k
POWER 9 volts DC maximum
2.1mm connector (Fig. 1)
CURRENT DRAW 60 mA maximum
DIMENSIONS L 4.7, W 3.7, H 2.3 inches
WEIGHT 1 lb.
MEMORY POSITIONS 4 preset, 1 expression
MIDI Expands memory to 100 total preset or expression
positions. Note: non-standard connector (page 19)
BYPASS SWITCHING Relay-based true bypass
CONSTRUCTION Two-stage progressive diode clipping, thin film
resistors, C0G capacitors, low noise op-amp, Neutrik
jacks, Alpha potentiometers.
POLICIES
POLICIES
To Next Page