23
Feel free to contact support@ramblefx.com at any time with questions or concerns.
Please do not attempt any repair or modification.
OPERATION AND CARE
Kismet is not intended to operate in an amplifier’s effects loop. Only connect
instrument level voltages to Kismet. Kismet needs power to operate its relay true bypass
switching. Using an isolated power supply can reduce noise. If one power supply is
powering multiple devices, make sure it is rated for the sum of all pedals’ current draw.
Kismet has no user serviceable parts internally. Not for human consumption.
TROUBLESHOOTING
STEP 1: Reset Kismet by disconnecting power from for 5 seconds then reconnect.
STEP 2:
STEP 3: Try different cables and supply, if possible.
If expression control does not work, follow the calibration procedure on page 18. If
calibration fails, it is connected incorrectly (see pages 11-12), or is incompatible.
If automatic MIDI channel setting (Page 20) fails, make sure it is connected properly
(Page 19). If the channel setting is successful and MIDI doesn’t work, make sure that
the controller being used is sending MIDI compliant Program Change or Control
Change messages. See midi.org for info.
OPERATION
OPERATION
24
PROGRAM CHANGE (PC) VALUES
PC VALUE FUNCTION
0 Live Settings
1, 2, 3, 4 Presets (only) 1, 2, 3, 4. These are the same 4 memory positions that can be
saved and recalled without MIDI.
5 Expression settings (only). This is the single expression setting that can be saved
and recalled without MIDI.
6 to 100 Positions 6 to 100 can store presets OR expression settings.
CONTROL CHANGE (CC) VALUES
CC VALUE FUNCTION SETTING
102 Toggle/Cycle footswitch Any
103 Bypass switching Below 63 = bypassed, above = ON
104 Bypass flip/flop Any
105 Bass setting 0 (min) to 127 (max)
106 Mids setting 0 (min) to 127 (max)
107 Treble setting 0 (min) to 127 (max)
108 Gain setting 0 (min) to 127 (max)
109 Volume setting 0 (min) to 127 (max)
110 Expression 0 (heel) to 127 (toe)
124 Omni mode OFF
1
0
125 Omni mode ON
1
0 NOTE: must be sent on the current channel
1
When omni mode is ON, Kismet responds to messages on all channels.
If step 1 didn’t fix it, isolate Kismet by connecting a guitar to Kismet, and
Kismet to amp only, with nothing else in the chain. Also, disconnect any
other devices that share the power supply.
To Next Page