1
Rammy Rotary mower maintenance instructions (3 sides).
TROUBLESHOOTING
The engine does not
start
The machine has run out of fuel
The fuel valve is closed
The ignition switch is OFF
Add fuel
Open the fuel valve
Turn the ignition switch to
ON
The switch is OFF
The belt is loose
The belt is broken
The clutch spring is broken
The drum is stuck
Turn the switch ON
Tighten the belt with the
spring or replace the belt
Replace the spring
Clean the drum and the
chamber
The mower does not
cut grass
The blades are dull
The blades not rotating
Sharpen the blades
Check the above
The engine is lacking
power
The engine runs on half speed
Dirt in air filter
Dirty fuel
Adjust the throttle cable
Change air filter
Clean carburetor and
nooze, change clean fuel
The shaft is unbalanced
Dirt or foreign objects in the
drum
Blades are broken
Change shaft
Clean the drum, the blades
and the chamber.
Change blades
A Rammy mower requires proper maintenance in order for it to function safely, reliably
and for a long time.
Grease the end bearings. The
proper dose is 1–2 strokes of the
lubricator. Excessive lubricant can
loosen the gasket. There are
grease nipples on the sides of the
bearings. Close the nipples with
plugs.
Tighten the mounting screws.
Check screw connections between
engine, transmission, and other
parts.joints of the engine, the
transmission and other parts.
Bearing
Vaseline;
working
temperature
-30… +60
degrees
Thread locking
glue
10 hours
2 hours after the
first start, and after
that 20 hours or one
season.
To Next Page
Need help?
General
