Need help?Do you have a question about the RAMSET T4 and is the answer not in the manual?
Emphasizes proper training, following instructions, and general safety precautions for tool operation.
Details safe handling, storage, and usage of fuel cells to prevent hazards.
Lists suitable base materials and warns against using others or brittle materials.
Explains how to perform a center punch test to determine material suitability for fastening.
Provides guidelines for spacing and edge distance when fastening into concrete.
Specifies edge distance and joint considerations for concrete block and masonry.
Details spacing and edge distance requirements for fastening into structural steel.
Instructs on correct tool handling, angles, and contact with the work surface.
Covers precautions like not carrying with finger on trigger and keeping tool locked up.
To Next Page
General