SR2 – 11
HARDWARE AND MISCELLANEOUS
1 SR2 printed circuit board
2 10K potentiometers (R14,21)
1 DPDT PC-mount push button switch (S1)
1 RCA-type PC-mount jack (J1)
1 Subminiature phone jack (J2)
1 9-volt battery snap connector
1 9-volt battery hold-down clamp
REQUIRED, NOT SUPPLIED:
9-volt alkaline or heavy-duty battery
Earphone, small speaker, or external amplifier with speaker
Antenna or suitable cable, connector, grounding
OPTIONAL
Ramsey SR2 case and knob set (CSR), or your own enclosure
To Next Page
Loading...