Assem- bly:
This
unit must be assem-
bled be- fore use.
Care must be
taken in assembly to
insure the
proper functioning of the unit. Assembly must be completed in a dry and clean
environment.
1.Position the trailer assembly on the ground in a clean and clear area. Mount the wheels by
slipping the wheel over the axle with the seal /bearing facing towards the inside. The
Nozzle stem should be on the outside of the tire.
2.Place the cotter pin through the pre drilled hole and bend the ends of the cotter pin over the
tip of the axle.
Do not operate this log splitter until you have read and understand the operating
and safety instructions. Failure to read and follow operating instructions can result
in serious injury or death to yourself and/or others.
To Next Page
Loading...