9
D) Dose size varies:
- Carefully clean the doser and the coffee dispenser outlet
- Check that the dosing lever can move freely and is not
obstructed in any way.
Identification details, specifications plate (Fig. 3)
1. Manufacturer
2. Model and version
3. Voltage
4. EC Conformity mark
5. Serial number
6. Pin
7. Total absorption
8. Motor power
9. - -
10. - -
11. Frequency
12. Conformity marks
13. Date of manufacture
Installation must be performed by a qualified technician.
The machine is delivered ready for installation according to the
data on the plate Fig. 3.
Check that the main power supply is compatible with the machine.
Check that the machine, the accessories, the supply cable and the
plug are intact, and in the event of damage, inform the retailer
promptly.
The machines have been designed and built for grinding coffee
beans for professional use.
Any other use is to be considered improper and thus dangerous.
To be carried out by a qualified technician.
For machines with 3-phase electrical supply, the correct rotation
of the motor should be checked.
- Start the grinder and check that grinding is performed
correctly. If this fails to occur, it means that the motor is
rotating in the wrong direction.
- Turn off the machine and the main power supply.
- Invert the two phase conductors, reassemble the machine
and try to perform the grinding operation again.
To be performed during installation and after burr replacement
The dosing grinders are tested with a random grind setting, and
will need to be readjusted. This operation should be carried out
with the bean hopper empty.
Hold down the adjustment unlock button (Fig. 2 – 1) and at the
same time slowly turn the adjustment knob (Fig. 2 – 3) counter-
clockwise until the burrs brush against each other (when they come
into contact, the sound of metallic friction can be heard), turn the
numbered ring (Fig. 2 – 2) so that the starting point 0 is frontal;
move the adjustment knob (Fig. 2 – 3) in the opposite direction
(clockwise), to position 10;
7. FIRST START-UP
7.1. Description of commands
KRYO 65/ST
Main switch (Fig. 1 – 9) with two positions; when switched on, the
machine is on and coffee grinding begins.
KRYO 65/AT
Main switch (Fig. 1 – 9) with two positions; in position (I), the
machine is on and will automatically shut-off when the doser
has been filled.
The coffee grinder is tested by the manufacturer with a medium
grind setting. The setting depends on the type of coffee used.
Adjust the grind setting only when the appliance is not in
operation. Never adjust when in use.
To Next Page
Loading...
Need help?
General
