30
It is forbidden to install or use the machine if
it is be wet or damp.
It is always necessary to request an accu-
rate check by qualified personnel in order
to find any possible damages to the electric
components.
4.1. Counter-instructions
This machine may be used only for the purposes
for which it was designed. It cannot be used to di-
spense products other than coffee or any non food
products.
The manufacturer cannot be held re-
sponsible for any damage caused by
unsuitable, erroneous or irrational use of
the machine.
5. TRANSPORT
5.1. Packaging
The machine must always be transported in a correct
position following the instructions on the cardboard
box.
Do not turn over the machine or lay it down
on a side.
The box also contains separate accessories and a
technical documentation which must be saved for
further consultations.
● Open the top part of the packaging, remove the
accessories and then remove the machine from
its packaging.
● Check if the machine, the accessories, the electric
cable and the plug are in perfect condition. Should
one of these parts be damaged, immediately con-
tact the retailer.
The packing elements (plastic bags, expan-
ded polystyrene, nails, cardboard, etc.) must
not be left within reach of children as they are
potential sources of danger.
Do not dispose of the packing elements in the
environment; consign them to firms authori-
zed for their disposal,
6. INSTALLATION
The machine is delivered ready to be installed in
accordance to the label data.
Ensure that the electrical supply system has
the same features as the machine.
The electrical supply system must be equip-
ped with a life saving device or a general
automatic switch with an efficient earthing
system. Should there be no electrical pro-
tection element, have a single-pole switch
installed by qualified personnel, as envisa-
ged by the current safety regulations with a
contact opening distance of either equivalent
or over 3 mm.
The earthing of the appliance is compul-
sory.
The constructor declines all responsibi-
lity in the event of the failure to respect
the accident prevention norms.
Take care not to damage the supply cable by
pressing, or crushing.
Do not disconnect the machine by pulling the
cable, but detach by gripping the plug.
The machine is not to be positioned in any niches or
similar difficult positions in order to prevent problems
relating to operation, supply and maintenance.
● The machine must be placed on a completely level
surface, that is both dry and sufficiently stable and
at a height of 80 cm from the ground.
● Position the machine and connect the plug to the
power socket.
To Next Page
Loading...
Need help?
General
