9
REAR PANEL: MONO 4-WAY AND MONO 5-WAY CONNECTIONS
Observe the labels below the Inputs and Outputs for Mono operation.
1. Mono Input: Connect the output from your mixer or other signal source only to the Mono 4W / 5W input for
Mono operation; do not use the Channel 2 input. Pin 2 is “hot” per AES standards.
2. Subwoofer Output: Connect the Sub Out to the input of the subwoofer (or bass bin) amplifier.
3. Low Output: Connect the Low Out to the input of the low frequency (mid-bass) amp.
4. Mid Output: Connect the Mid Out to the input of the mid frequency amplifier.
5. High-Mid Output (for mono 5-way only): Use this output only for Mono 5W applications. Connect the High-
Mid Out to the input of the high-mid frequency amplifier. Do not use this output when using the AC 23S as a
Mono 4W Crossover. In 4W, the AC 23S internally bypasses the High-Mid section and defeats all front panel
High-Mid controls.
6. High Output: Connect the High Out to the input of the high frequency (tweeter) amp.
7. Stereo / Mono Switch: Push this to the Mono (in) position.
8. Stereo 2-Way / 3-Way Switches: For Mono 4W or 5W, slide these switches to the 3W position.
9. Mono 4-Way / 5-Way Switch: In 4W, the High-Mid output duplicates the Mid output frequencies with a
different low pass setting as determined by the High-Mid / High frequency control, and is not normally
recommended for use since the tweeter crossover point will be inaccurate.
10. Power Input: Connect the included power cable here. Do not lift the ground connection!
If your 4-way system needs a higher range of 190 Hz-7 kHz for Low / Mid, see the configuration on the
following page.
10
To Next Page
Loading...
