Need help?Do you have a question about the Rane ME 15 and is the answer not in the manual?
Audio Specifications| constant-Q bandpass filters ME 15 bandwidth | 2/3 octave |
|---|---|
| constant-Q bandpass filters ME 15 frequency range | 25-16 kHz |
| constant-Q bandpass filters ME 30 bandwidth | 1/3 octave |
| constant-Q bandpass filters ME 30 frequency range | 25-20 kHz |
| boost/cut range | ±6 dB or ±12 dB |
| built-in low cut filter | -3 dB at 20 Hz (18 dB per octave) |
| built-in ultrasonic filter | -3 dB at 60 kHz (6 dB per octave) |
| overall gain range | Off to +6 dB |
| frequency response | 20 Hz to 60 kHz, +0/-3 dB |
| signal to noise ratio (boost/cut centered, unity gain) | 108 dB below +20 dBu |
| signal to noise ratio (boost/cut centered, maximum gain) | 107 dB below +20 dBu |
| THD + noise | Less than .009%, 20 Hz to 20 kHz, @ +4 dBu (1.23V) output |
| intermodulation distortion (SMPTE) | less than .005% @ +4 dBu output |
Electrical Specifications| input impedance | 20, 000 ohms |
|---|---|
| output impedance | 100 ohms |
| maximum input level | +21 dBu (9 Volts) |
| maximum output level | +21 dBu (9 Volts) |
Weight and Dimensions| dimensions | 1.75" H x 19" W x 5.25" rack depth |
|---|---|
| weight | 5 Ib |
| chassis material | all steel |
Details the purpose and function of each button, switch, slider, and LED on the front panel.
Explains the stereo 1/4" jacks for input and output, including wiring for balanced and unbalanced signals.
Explains how to use the equalizer for acoustical correction rather than tone shaping individual instruments.
Provides recommendations on where to position the equalizer in the audio signal chain for optimal performance.
Recommends using a realtime analyzer and listening to achieve optimal sound system equalization.
To Next Page
