Rane Pacific RC2 - Using the Tub

Using the Tub
Operating Instructions:
 To open the door, pull upward on door handle
 Step inside tub and lower yourself to the contoured seat.
 Push door shut, grasp handle and push forward until the handle stops and the door is in the locked position.
 Turn the diverter lever towards the tub spout and turn on the water. Check the temperature with your hand
as you fill tub, adjust the temperature accordingly.
 Insert the drain plug or close the drain using the cable drain knob (if equipped)
 Fill the tub to the desired level.
 To use the shower wand, turn the diverter lever towards the shower wand until the water comes out of the
shower wand.
 When finished bathing, pull the drain plug or open the drain using the cable drain knob (if equipped)
 When the tub is empty, open the door and exit the tub.
TEMPERATURES OVER 110 DEGREES FAHRENHEIT CAN SCALD!
Section 2.1
Shower Wand
Diverter Lever
Drain / Drain Plug
Tub-Fill Spout