EasyManua.ls Logo

Rane RK12 - General Safety Instructions

Rane RK12
9 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
INSRUCTIONS PERTAINING TO A RISK OF FIRE,
ELECTRICAL SHOCK, OR INJURY TO PERSONS
READ AND FOLLOW ALL INSTRUCTIONS
WARNING - When using this unit, basic precautions should always be followed, including the
following:
READ AND FOLLOW ALL INSTRUCTIONS.
DANGER: To reduce the risk of injury, do not permit children to use this unit unless
they are closely supervised at all times
Use this unit only for its intended use as described in this manual. Do not use
attachments not recommended by the manufacturer.
Never drop or insert any object into any opening.
Do not operate this unit without the guard over the suction fitting.
The unit must be connected only to a supply circuit this is protected by a ground-fault
circuit-interrupter (GFCI). Such a GFCI should be provided by the installer and should
be tested on a routine basis. To test the GFCI, push the test button. The GFCI should
interrupt power. Push the reset button. Power should be restored. If the GFCI fails to
operate in this manner, the GFCI is defective. If the GFCI interrupts power without the
test button being pushed there is a ground current flowing, indicating the possibility of an
electric shock. Do not use this hydromassaged tub. Disconnect the hydromassaged
bathtub and have the problem corrected by a qualified service representative before
using.
(For permanently connected units) A green colored terminal (or a wire connector marked
“G”, “GR”, “Ground”, or “Grounding”) is provided within the terminal compartment. To
reduce the risk of electric shock, connect this terminal or connector to the grounding
terminal of your electric service or supply panel with a conductor equivalent in size to
the circuit conductors supplying this equipment.
DANGER: RISK OF ELECTRICAL SHOCK. Connect only to a circuit
protected by a ground-fault circuit-interrupter.
Grounding is required. The unit should be installed by a qualified
service representative and grounded.
(For built-in and custom units) Install to permit from servicing.
SAVE THESE INSTRUCTIONS