EcoPro
Range Road Enterprises Ltd
Box 944
Eckville AB T0M 0X0
www.range-road.ca
11. Log Roller Bar/Infeed: Shown is the RR2504 hydraulic infeed (optional) When the log roller or infeed is
unfolded it allows longer logs to be loaded onto the Log Deck manually of hydraulically.
12. Saw Bar Handle: Use the saw bar handle to draw the chain saw bar down, run the chain, and to move the
splitter ram forward.
13. Bar Oil Tank: Fill this with bar oil to lubricate the cutting chain.
14. Safety Sticker
15. Manual Engagement Lever: Pushing this down manually engages the splitting ram.
16. Battery
17. Fender
18. Wedge Height Adjuster: The lever raises and lowers the splitting wedge for splitting different diameter
logs.
19. Log Hold Down: Push the lever forward to put pressure on the log and hold it in place.
20. Splitter/Chainsaw Safety Cover: This cover has to be in the down position for hydraulics to operate,
when lifted up the chainsaw and splitter will stop and not operate until it is lowered again.
21. Conveyor Winch: Use the winch to adjust the angle of the conveyor.
22. Conveyor Belt: The belt moves the wood up the conveyor, it should be tensioned so that if a piece of wood
jams, the belt will stop moving.
23. Conveyor Leg: When conveyor is unfolded the safety chain must be attached to this leg to keep the
conveyor at the desired height.
24. Output Conveyor: Shown folded up in travel mode, when unfolded the conveyor can be adjusted to the
output height needed.
25. Hydraulic Control: When accessories are added like the RR2504 Hydraulic infeed, a Hydraulic control
valve is mounted in this location.
26. Toolbox, Emergency Stop switch, Hour Meter
To Next Page
Loading...
