EasyManua.ls Logo

Range Rover L322 - Page 93

Range Rover L322
494 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DESCRIPTION AND OPERATION
4.68 RANGE ROVER
WIPERS AND WASHERS
DESCRIPTION
General
The wipers and washers system is controlled by the Body Control Unit (BCU) on receipt of
requests made by the driver or the rain sensor unit (if fitted). All wiper functions for the front
and rear wipers are controlled from a multifunction wash/wipe switch assembly located on
the right hand side of the steering column.
Optional equipment on Range Rover includes a rain sensor. The sensor, located below the
interior rear view mirror, detects rain drops on the windscreen and automatically operates
the wipers in the intermittent mode.
NOTE: The column stalk switch must be in the intermittent position for rain sensor controlled
wiper operation.
The front wiper system has four stages of wiper operation with four different delay periods
for intermittent wipe. The four stages are as follows:
l Flick wipe
l Intermittent
l Normal (slow) speed continuous
l Fast speed continuous.
The intermittent wiper delay periods change with the road speed, with the delay decreasing
as the road speed increases. Normal continuous operation changes to intermittent operation
when the vehicle is stationary. Fast speed operation changes to normal operation when the
vehicle is stationary.
For a detailed description of the wipers and washers, refer to the Wipers and Washers
section of the System Description and Operation Workshop manual.