EasyManua.ls Logo

Range Rover L322 - Page 94

Range Rover L322
494 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DESCRIPTION AND OPERATION
RANGE ROVER 4.69
OPERATION
Front
Power Distribution
Feed from the positive battery terminal (C0192) is supplied to fuse 26 and fuse 53 of the
passenger compartment fuse box (C0632) on an R wire. Fuse 26 (C0583) provides a
constant battery feed to the wiper delay ECU (C0546) on an RW wire.
Fuse 53 (C0583) provides a constant battery feed to the ignition switch (C0099 on Td6
vehicles, C0028 on V8 vehicles) on an R wire. When the ignition switch is turned to the
'auxiliary' position, current flows across the switch (C0099 on Td6 vehicles, C0028 on V8
vehicles) to fuse 41 of the passenger compartment fuse box (C0585) on a PB wire. Fuse 41
(C0586) provides an auxiliary ignition feed to the Body Control Unit (BCU) (C0660) on a PW
wire, and the rain sensor (C0961) on a PR wire.
Rain Sensor
The rain sensor (C0961) is mounted on the upper edge of the windscreen. It is provided an
auxiliary ignition feed from fuse 41 of the passenger compartment fuse box (C0586) on a PR
wire, and is earthed on an NB wire. The rain sensor (C0961) provides information to the BCU
(C0660) via the K bus on a WRY wire. This information is used by the BCU to determine
optimum wiper operation for the prevailing conditions.
Steering Wheel Switch
The BCU (C0660) provides feeds to the steering wheel switches (C0278) on BW and BU
wires. The steering wheel switch (C0278) is earthed on an NB wire. The BCU determines
which function has been selected by the earth paths that are created by the switch. If slow
wipe is selected, current on the BW wire flows across the switch to earth. If fast wipe is
selected, current on both the BW and BU wires flows across the switch to earth. If
intermittent wipe is selected, current on the BU wire flows across the switch to earth.
The steering wheel switch also contains a rotary potentiometer to control the intermittent
wipe function. The intermittent wipe setting is interpreted by the BCU (C0661) from the feed
returned from the switch (C0278) on a BG wire.
When the BCU (C0661) senses that wiper operation is required, it provides a feed to the
wiper delay ECU (C0546) on an NU wire. The wiper delay ECU (C0546) is earthed on an N
wire and provides two feeds to the wiper motor (C0546) on BG and BN wires.
Washer
If the steering wheel switch is pulled towards the driver, current flows from the BCU (C0660)
to the steering wheel switch (C0278) on an NP wire, and then to earth on an NB wire.
Sensing this earth, the BCU (C0662) provides a feed to the washer pump motor (C0008) on
a B wire. Current flows across the washer pump motor (C0008) to earth on an N wire. The
BCU powers the washer pump motor for as long as the switch is held in position, and also
powers the wipers at slow speed.