EasyManua.ls Logo

Range Rover L322 - Page 96

Range Rover L322
494 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DESCRIPTION AND OPERATION
RANGE ROVER 4.71
HEADLAMP WASH/WIPE
DESCRIPTION
General
Operation of the headlamp wash/wipe system is controlled by the Body Control Unit (BCU)
via the headlamp wash/wipe relay. Headlamp wash/wipe is activated automatically when the
ignition and the headlamps are switched on, and windscreen wash/wipe is selected via the
column switch. The headlamp wipers will operate through four cycles, with the washer jets
spraying twice. This operation is only carried out on the first windscreen wash/wipe request,
and then every fifth request from then on. This sequence is reset when the ignition is
switched off.
For more information on headlamp wash/wipe, refer to the Wipers and Washers section
of the System Description and Operation Workshop Manual.
OPERATION
Power Distribution
Feed from the positive battery terminal (C0192) is supplied to fuse 28 and fuse 53 of the
passenger compartment fuse box (C0632) on an R wire. Fuse 28 (C0582) provides a
constant battery feed to the following on RS wires:
l The headlamp wash/wipe relay (C2031)
l The RH headlamp wiper motor (C1341)
l The LH headlamp wiper motor (C1340).
Fuse 53 (C0583) provides a constant battery feed to the ignition switch (C0099 on Td6
vehicles, C0028 on V8 vehicles) on an R wire. When the ignition switch is turned to the
'auxiliary' position, current flows across the switch (C0099 on Td6 vehicles, C0028 on V8
vehicles) to fuse 41 of the passenger compartment fuse box (C0585) on a PB wire. Fuse 41
(C0586) provides an auxiliary ignition feed to the BCU (C0660) on a PW wire. The BCU
(C0662) is earthed on an N wire.
Headlamp Wash/Wipe Relay
When the BCU (C0661) determines a wash/wipe selection has been made, it provides a
pulsed voltage feed to the headlamp wash/wipe relay (C2031) on a UB wire. The headlamp
wash/wipe relay (C2031) is earthed on an NB wire. When this feed is received, circuitry
contained within the relay converts this signal into a headlamp wash/wipe request and
closes the relay switch contacts. This allows a feed to be provided to the RH headlamp
motor (C1341) and the LH headlamp motor (C1340) on a pair of BN wires. Current flows
across the motors to earth on N wires.