DESCRIPTION AND OPERATION
4.72 RANGE ROVER
BRAKE AND REVERSE LAMPS
DESCRIPTION
Brake Lamps
The brake lamps are active with the ignition switch in the 'auxiliary' or 'ignition' positions. The
Light Check Module (LCM) receives an input from the brake switch, which is used as a signal
to activate the brake lamps. When Hill Descent Control (HDC) is active, the ABS ECU
outputs a signal on a separate hardwired connection to the LCM to activate the brake lamps
when the HDC function is operating.
For more information on brake lamp operation, refer to the Exterior Lamps section of the
System Description and Operation Workshop Manual.
Reverse Lamps
The reverse lamps will operate when the ignition switch is in the 'ignition' position. The LCM
activates the reverse lamps on receipt of a message on the I Bus that reverse gear has been
selected.
For more information on reverse lamp operation, refer to the Exterior Lamps section of
the System Description and Operation Workshop Manual.
OPERATION
Power Distribution
Feed from the positive battery terminal (C0192) is supplied to fusible link 3 and fuse 53 of
the passenger compartment fuse box (C0632) on an R wire. Fusible link 3 (C0589) provides
a constant battery feed to the Light Check Module (LCM) (C0937) on an R wire.
Fuse 53 (C0583) provides a constant battery feed to the ignition switch (C0099 on Td6
vehicles, C0028 on V8 vehicles) on an R wire. When the ignition switch is turned to the
'auxiliary' position, current flows across the switch (C0099 on Td6 vehicles, C0028 on V8
vehicles) to fuse 9 of the passenger compartment fuse box (C0585) on a PB wire. Fuse 9
(C0587) provides an auxiliary ignition feed to the LCM (C2040) and the brake pedal switch
(C0075) on a pair of PY wires.