DESCRIPTION AND OPERATION
RANGE ROVER 4.73
Brake Lamps
The LCM (C2040) monitors the condition of the brake pedal via the brake pedal switch
(C0075) on a UR wire. When the brake pedal is pressed, the switch contacts close and an
earth path is created on an NB wire. Sensing this, the LCM (C0937) provides a feed to the
following on BU wires:
l The RH brake lamp (C0125)
l The LH brake lamp (C0121)
l The Centre High Mounted Stop Lamp (CHMSL) (C0613).
All are earthed on N wires.
When HDC is functioning, the ABS ECU (C0506) outputs a signal to the LCM (C2040) on a
YN wire. When the LCM receives this signal, it operates the brake lamps as described
above. For more information on ABS operation, refer to the Anti-Lock Braking System
(ABS) section of this manual, and the Brakes section of the System Description and
Operation Workshop manual.
+ ANTI-LOCK BRAKING SYSTEM (ABS).
Reverse Lamps
When reverse gear is selected, a message is sent from the Electronic Automatic
Transmission (EAT) ECU (C1835) to the Engine Control Module (ECM) (C0604) via the
CAN Bus on YN (low) and YB (high) wires. This message is relayed from the ECM (C0331)
to the instrument pack (C0234) via the CAN Bus on YN (low) and YB (high) wires
When the instrument pack receives this message, it outputs a signal to the LCM (C2040) via
the I Bus on a WSY wire. When the LCM (C2039) receives a reverse gear selected signal,
it provides a feed to the following on WY wires:
l The RH reverse lamp (C0455)
l The LH reverse lamp (C0472).
Both lamps are earthed on N wires.