4
Safety Guidelines
Before using device, read and understand the user manual, including
these additional safety instructions. Failure to do so could result in
DEATH or SERIOUS INJURY.
• Do not exceed legal speed limits on public roadways. Violating trac laws is
dangerous and could result in injury or vehicle damage or both.
• Use any enhanced speed capabilities of this product only in closed circuit, legally
sanctioned racing environments expressly for this purpose. Violating trac laws is
dangerous and could result in injury or vehicle damage or both.
• Do not operate the device while driving. Distracted driving could result in trac
accidents, death or serious injury, and/or damage to your vehicle.
• Always perform all adjustments or changes while stopped. Changing a setting while
driving can interfere with your attention to roadway conditions and could result in
injury or vehicle damage or both.
• Do not stack products. “Stacking” performance-enhancing devices or other
improper installation can cause power train failure on the road. Other products may
have features incompatible with your device. Follow all installation and operating
instructions.
• Some modications may aect other parts of your vehicle. For example, if you
remove/adjust the speed limiter in your vehicle, be sure your tires and other
components are rated for the increased speeds they will have to withstand. Not
doing so can lead to loss of vehicle control. Modify the speed limiter only for use
in closed circuit, legally sanctioned racing environments, not for use on public
roadways.
WARNING
NOTE: The stickers included in some products apply to products that have
recieved CARB exemption for emissions compliance.
This product may meet the emissions compliance
requirements of the California Air Resources Board (CARB)
and Federal Environmental Protection Agency (EPA). If so,
it is legal for sale and use on pollution-controlled vehicles
operated on public streets and highways. The device must
be installed and operated according to the instructions
provided in this user’s manual. Included with these compliant products is a sticker (similar
to the one pictured above) for you to install in your vehicle. Please clean a at visible
surface under the hood and ax the enclosed CARB EO sticker for SMOG purposes. An
example of the need for this sticker would be something to show an emissions technician
when taking your vehicle in for an emissions check to let him/her know the product is
CARB emissions compliant.
For more information regarding CARB and EPA compliant products, please check out our
website: www.holley.com - or mail us via: 1801 Russellville Rd, Bowling Green, KY 42101
To Next Page
Loading...