Need help?Do you have a question about the Ranger Tugs R-29 and is the answer not in the manual?
Information on potential chemical exposure and safety precautions for operating a marine vessel.
Symbols indicating important instructions or hazards requiring attention.
Symbols representing different onboard systems and indicators.
Symbols used to differentiate between standard and optional equipment.
Symbols indicating helpful tips for operation or maintenance.
Technical specifications for the Ranger Tug R-29 Sedan model.
Technical specifications for the Ranger Tug R-29 Command Bridge model.
Identifies and labels fittings located on the starboard side of the vessel.
Lists standard equipment fittings located on the port side of the vessel.
Lists optional equipment fittings located on the port side of the vessel.
Identifies standard equipment located on the main cabin's top deck.
Identifies optional equipment located on the main cabin's top deck.
Details standard components located at the stern of the boat.
Details optional components located at the stern of the boat.
Diagram and table showing main cabin and cockpit lighting controls and locations.
Diagram and description of the fuel system for the engine, generator, and furnace.
Explains the closed engine cooling system, its purpose, and coolant recommendations.
Details the raw water and sea strainer system for engine and generator cooling.
Describes the optional A/C raw water intake system.
Diagram and explanation of the fresh water plumbing system, including tank and pump.
Details the shower sump system, its capacity, and location.
Explains the bilge pump system, operation, and alarm locations.
Describes the waste tank, macerator pump, and overboard discharge system.
Diagram showing the location of various electric pumps on the vessel.
Indicates optional electric pumps installed on the vessel.
Details the optional air conditioning system, including units, vents, and controls.
Describes the location and operation of the optional Webasto furnace.
Information on the optional solar panel, its charging capabilities, and display.
Details the vessel's battery setup, including house, engine, and thruster batteries.
Identifies fuse block locations and values for navigation, dash 1, and dash 2 circuits.
Explains the reset and test procedure for the windlass breaker.
Details fuse block locations and values in the midberth for various systems.
Shows fuse block location and values under the bridge dash.
Location and components of the power panel for the Command Bridge.
Details the power panel components for the Sedan model, including breakers and fuses.
Explains the AC distribution panel and its rotary switch for power source selection.
Details the AC distribution panel and rotary switch when equipped with a generator.
Explains operation of 12V systems controlled from the helm, including bilge alarms and heater.
Wiring schematic for accessory circuits powered by +12V, including dash fuse blocks.
Wiring schematic for accessory circuits connected to the -12V ground.
Wiring schematic for additional accessory circuits powered by +12V.
Wiring schematic for accessory circuits connected to the -12V ground.
Wiring schematic for PDP fuse block accessories powered by +12V.
Wiring schematic for accessories connected to the -12V ground.
Wiring schematic for lighting circuits powered by +12V, including dash fuse blocks.
Wiring schematic for lighting circuits connected to the -12V ground.
Details power distribution path to the bridge fuse block.
Shows power distribution path to the AC panel.
Illustrates the ground bus connections for power distribution.
Diagrams of the working deck layout for R-29 CB and R-29 S models.
Step-by-step instructions for setting up the mast on the vessel.
Step-by-step instructions for taking down the mast from the vessel.
Checklist for preparing the tow vehicle, trailer, and boat for road travel.
Checklist items for cleaning the boat before launching for the season.
Checklist items for inspecting various systems and components before launching.
Items to check for safety equipment compliance before launching.
Checklist items for the galley before launching.
List of essential documents to have on hand before launching.
Checklist for general maintenance tasks before winter storage.
Checklist for engine preparation and maintenance for winter storage.
Checklist items for the galley before winter storage.
Location of the warning label for windlass operation.
Location of the warning label concerning visibility from the helm.
Location of the warning label for LPG appliances.
Location of the warning label for fire or explosion hazards.
Location of the warning label for the transom door status.
Location of the warning label regarding prohibited fuel storage.
General| Brand | Ranger Tugs |
|---|---|
| Model | R-29 |
| Category | Boat |
| Language | English |
To Next Page
