Ranger 90032 - Instructions for Use; Attaching the Pressure Infusor to the IV. Pole; Operating the Pressure Infusor

11 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

Ranger

Pressure

Infusor

and

Power

Pack

instructions

for

Use

Attaching

the

Pressure

Infusor

to

the

IV.

Pole

Mount

the

pressure

infusor

onto

the

LV.

pole.

The

pole

diameter

should

be

between

0.75"

(1.9

cm) and

1.5"

(3.8

cm)

with

a

minimum

25°

(63.5

cm)

diameter

5-point

base.

The

distance

between

the

pressure

infusor

and

the

floor

should

not

be

greater

than

56"

(142

cm).

2.

Securely

fasten

the

clamps

at

the

back

of

the

infusor and

tighten

the

knob

screws

until the

infusor

is

stable.

Connecting

the

Pressure

Infusor

to

Compressed

Nitrogen

or

Air

Bottles/Tanks

Bottled,

tank,

or

wall

compressed

air,

CO»,

or

nitrogen

can

be

used

if

the

power

pack

is

not

used.

The

pressure

infusor

includes

a

fitting

that

allows

it

to

be

connected

to

the

regulator

of

a

compressed

air,

CO»,

or

nitrogen

tank.

WARNING:

The

compressed

gas

tank

must

be

equipped

with

a

low

pressure

regulator

which

should

also

be

equipped

with

a

pressure

gauge.

Output

pressure

must

not

exceed

60

psi.

Operating

the

Pressure

Infusor

Waming:

Remove

excess

air

from

IV.

solution

containers.

1.

Flip

the

switch

to

“OFF”

before

opening

the

door.

2.

Open

the

infusor

door

by

releasing

the

metal

latch

on

the

right

side

of

the

unit.

3.

Spike

the

LV.

solution

container.

Place

the

solution

bag

behind

the

bag

retainer.

4.

Make

sure

the

disposable

set

tubing

hangs

freely

from

the

pressure

infusor.

Close

the

door

securely.

5.

Prime

the

disposable

set.

6.

Flip

the

switch

to

“ON.”

7.

To

change

or

remove

the LV.

solution

bag:

Flip

the

switch

to

“OFF”

Open

the

door,

remove

the

LV.

solution

bag.

Press

on

the

infusor's

bladder

to

expel

the

remaining

air

and

insert

a

new

LV.

bag

if

desired.

Close

the

door

securely.

Flip

the

switch

to

“ON.”

CAUTION:

[f

the

pressure

infusor

is

ON

while

the

door

is

open,

the

inflation

bladder

is

designed

to

detach

from

the

inflation

port.

This

prevents

the

bladder

from

rupturing.

Reinstall

the

bladder

by

snapping

its

grommet

onto

the

inflation

port

located

in

the

cavity

of

the

unit.

Realign

the

bag

in

the

cavity.

Arizant

Healthcare

Inc.

TI

기

그

기

그

JI

1

J3

31

OII

Table of Contents