Rankam GR2298901-GS-00

Questions and Answers

T
Tamara MartinAug 11, 2025
Why won't the burner light on my Rankam Griddle?
- J
  Johnny JonesAug 11, 2025
  If the burner on your Rankam Griddle won't light, here's what to check: * The LP cylinder may be empty. If so, replace it with a full one. * The electrode tip might not be positioned correctly. It should point toward the gas port opening on the burner, about 1/8” to 1/4” away. Adjust if needed. * The burner might not be seated properly. * The burner may be obstructed. * The cylinder valve might be closed. Check and open it. * The regulator may not be properly seated on the cylinder valve.
A
angela72Aug 16, 2025
What to do if there is a fire at the control knob of my Rankam Griddle?
- T
  Tina VegaAug 17, 2025
  If you're experiencing a fire at the control knob of your Rankam Griddle, the possible causes are: * The burner is improperly seated on the control valve. * Gas connections may be loose. Check and tighten all connections. * Burner holes may be obstructed.
W
wendyfowlerAug 22, 2025
Why is my Rankam Griddle too hot?
- C
  Chris GravesAug 22, 2025
  If your Rankam Griddle is too hot, this could be due to: * Excess grease build-up causing grease fires. * A damaged or faulty regulator. Replace any damaged parts with factory authorized components.
A
april05Aug 28, 2025
What to do if the flame blows out on “LOW” on my Rankam GR2298901-GS-00 Griddle?
- U
  uandersonAug 28, 2025
  If the flame on your Rankam Griddle blows out on the “LOW” setting, consider these possibilities: * Burner holes may be obstructed. * The grill might not be sufficiently preheated. Make sure to preheat it for an adequate amount of time. * The burner may be improperly seated on the control valve.
T
tara95Sep 4, 2025
How to fix a Rankam GR2298901-GS-00 Griddle burner that does not get hot enough?
- D
  Dr. Jenna GreenSep 4, 2025
  If the burner on your Rankam Griddle isn't getting hot enough, the flow control device in the regulator may have been activated. To reset it, turn off all burners and close the LP tank valve. Disconnect the regulator from the LP tank and wait one minute. Reconnect the regulator to the LP tank, slowly open the LP tank valve fully. Light all burners and check the temperature.