Rankam Member's Mark GR2298901-MM-02 User Manual (English)

Other manuals for Rankam Member's Mark GR2298901-MM-02

Assembly Instructions & User Manual34 pages

Questions and Answers:

P
Paula DunnAug 1, 2025
How to fix a Rankam Griddle burner that will not light?
- B
  Brittany NelsonAug 1, 2025
  If the burner on your Rankam Griddle won't light, several factors could be at play. First, check if the LP cylinder is empty and replace it with a full one. Ensure the electrode tip is correctly positioned, pointing towards the gas port opening on the burner, with a distance of 1/8” to 1/4”. Also, verify that the burner is properly seated and not obstructed. Check that the cylinder valve is open and that the regulator is correctly seated on the cylinder valve.
L
Laura SantosAug 5, 2025
What to do if there is a fire at the control knob of my Rankam Member's Mark GR2298901-MM-02?
- M
  Mr. James RussoAug 5, 2025
  If you're experiencing a fire at the control knob of your Rankam Griddle, it could be due to a few reasons. The burner might not be correctly seated on the control valve. Also, gas connections might be loose, so it's important to check and tighten them. Another possibility is that the burner holes are obstructed.
P
Patrick WalkerAug 10, 2025
Why is my Rankam Member's Mark GR2298901-MM-02 too hot?
- J
  Jeffrey HernandezAug 10, 2025
  If your Rankam Griddle is too hot, it might be because of excess grease build-up causing grease fires or a damaged/faulty regulator. If the regulator is the cause, replace the damaged parts with a factory authorized component.
M
Mary BerryAug 14, 2025
What to do if the flame blows out on “LOW” on my Rankam Griddle?
- K
  kcareyAug 14, 2025
  If the flame on your Rankam Griddle blows out on the “LOW” setting, it could be due to obstructed burner holes or the grill not being sufficiently preheated. Make sure to preheat the grill for an adequate amount of time. Another possible cause is that the burner is improperly seated on the control valve.
A
Alexander GatesAug 18, 2025
Why does the burner on my Rankam Griddle not get hot enough?
- T
  Timothy HowardAug 18, 2025
  If the burner on your Rankam Griddle isn't getting hot enough, the flow control device in the regulator may have been activated. To reset it, turn off all burners and close the LP tank valve. Disconnect the regulator from the LP tank and wait one minute. Reconnect the regulator to the LP tank, slowly open the LP tank valve fully, then light all burners and check the temperature.