AD-128 Page 3 of 3
Rear lift struts with adjustable lower end:
1. Inspect connection of rod end and adjuster end at lower rear strut attach for thread
engagement of at least 10 full threads. Visually inspect condition of threads. Replace worn
parts with new parts.
2. Add and tighten stop nut during reassembly (refer to Figure 2). Retain and check wing
wash out as per assembly manual. Note: Figure 2 is for larger strut shown. Smaller strut
fitting is of square block design.
Figure – 2 Lower end of adjustable rear lift strut
The stop nuts are available through our parts department. Order: 3/8” Plain Nut MS35650-3382.
Thank you for your attention to this matter. Hopefully we have not inconvenienced you to any great
degree.
Fly safe.
To Previous Page
Loading...
