Rapid Release PRO2 - Follow Up Sessions for Pro2; General Guidelines for Pro2 Use; Specifications for Rapid Release Pro2

To Next Page

To Previous Page

10-008 Rev 5 02/28/17

FOLLOW UP SESSIONS

During follow up sessions, treatment area should be expanded to cover

all structures linked to your target area. For example: working around the

shoulder apply the Rapid Release Pro2 down the entire arm to the ngers

and back to the upper chest and all around the shoulder blade area. After

the rst few sessions you can change position to stretch the area or target

the area from a dierent angle. You can also change the body position or

apply while weight bearing.

Remember the Rapid Release Pro2’s eectiveness derives from its unique

frequency therefore too much pressure can compress the tissue and limit

the penetration of the vibration.

GENERAL GUIDELINES

• There is no observed benet to sessions lasting longer than

5 minutes per area.

• Use common sense when using the Rapid Release Pro2.

• When in doubt, always err on the side of caution.

See our website www.RapidReleaseTech.com for updated instructions.

SPECIFICATIONS

Leakage current: none

Length: 10.5 in.

Cord Length: 9 ft.

Weight: 2.2 lbs. without cord

Weight: 2.7 lbs. with cord

Frequency: 155Hz +- 10%