14
Switch ON for approx 2 sec.
Green LED will flash for approx 20 sec.
(pre-heating)
Applicator ready for Use.
Press ON/OFF button for approx 2 sec to
switch OFF the applicator when job is finish
No use/glueing for approx 3 min :
glue gun automatically switches OFF for
safety
Press button ON to re-start
Red and green LED flashes alternately after
glue gun has been used for approx 25 min.
Battery almost empty applicator can now
only be used for approx 5 min
Red flash only or no more LED : battery is
empty, re-load it by using USB charger
CHARGING INSTRUCTIONS
– Connect the USB cable onto charger and micro USB socket at the
back of the tool
– Connect the charger to the mains.
– The LED on the glue gun will flash red during the charge., and will
turn to fix green when battery is fully charge
– During the process of charging, the charger and glue gun can
become warm, this is normal.
Charging with USB charger
LED Red LED green
Battery is charging
Battery is fully charged
MAINTENANCE
– Unplug the tool before any maintenance.
– Keep the air intake and outlet free from dust and dirt.
– Clean the tool by a dry or damp cloth. NEVER use any solvent.
– DO NOT oil or grease any parts.
– Be sure the tool is not damaged. Replace or repair prior to use.
WARNING!
– DO NOT alter or parts on this tool or attach special fixtures. This can
lead to personal injury.
ENVIRONMENT!
Separate Collection. Do not dispose power tools into house-
hold waste! According to the European Directive 2012/19/EC
on waste of electrical and electronic equipment.
When the tool needs to be replaced, or if it is of no further use it
should be brought to a separate collection centre for recycling.
The appliance and the battery must be disposed of separately.
To do this, unscrew/open the appliance, cut the battery connection
cable and remove the battery from the appliance.
WARRANTY
Warranty period: This product is guaranteed for 2 years from the
date of purchase (original sales receipt acting as proof).
Warranty conditions: All points mentioned in this document must
have been fully adhered to.
In the event of a claim under the warranty:
1 Return the product in its original packaging to the shop or outlet
that supplied you with this product,
2 Accompany the returned product with the original dated receipt.
Any breach of one of these points would prevent consideration by
RAPID under the manufacturer’s warranty.
BGX7_Manual_East_95x125_20191203.indd 14 2019/12/3 上午11:28
To Next Page
Loading...
