Rapid R1800 - Maintenance and Specific Hot Air Tool Safety; Tool Service and Handling; Hot Air Tool Usage Precautions

7
edges are less likely to bind and
are easier to control.
g) Use the power tool, accesso-
ries and tool bits etc. in ac-
cordance with these instruc-
tions, taking into account the
working conditions and the
work to be performed. Use of
the power tool for operations dif-
ferent from those intended could
result in a hazardous situation.
5) SERVICE
a) Have your power tool serviced
by a qualifi ed repair person
using only identical replace-
ment parts. This will ensure that
the safety of the power tool is
maintained.
HOT AIR TOOL SAFETY
WARNINGS
WARNING: This tool must be
placed on its stand when not in
use.
A fi re may result if the appliance
is not used with care, therefore
– be careful when using the ap-
pliance in places where there
are combustible materials;
– do not apply to the same
place for a long time;
– do not use in presence of an
explosive atmosphere;
– be aware that heat may be
conducted to combustible
materials that are out of sight;
– place the appliance on its
stand after use and allow it to
cool down before storage;
– do not leave the appliance un-
attended when it is switched
on.
– This appliance can be used
by children aged from 8 years
and above and persons with
reduced physical, sensory or
mental capabilities or lack of
experience and knowledge if
they have been given supervi-
sion or instruction concerning
use of the appliance in a safe
way and understand the haz-
ards involved.
– Children shall not play with
the appliance.
– Cleaning and user mainte-
nance shall not be made by
children without supervision
TECHNICAL SPECIFICATION
Model
Feature
R1800 R2000 R2200-E
R2200-
LCD
Voltage 230-240V~ 50-60Hz
Power, Watt 1800 2000 2200 2200
Power switch
Power/Air
flow
0 OFF
- 1 Low/Full
1 Mid/
Mid
2 Mid/Mid
2 High/
Full
3 High/Full
Power/Air
flow
LED indicator
-
-
-
Yes, see
features
Temperature
indicator
screen
---
Yes, see
features
Residual Heat
Warning
- - Yes, see features
FEATURES
Power switch, fi g 1A
Nozzle, fi g 1B
Handle, fi g 1C
Stand for vertical operation with
free hands or storage. Fig 4G