RAS MULTIBEND 9000 - Page 19

IffASI
"V
sAt-ts,I
Y
The operator must
ensure that it
is not
possible
to start the
machine by accident.
Always turn
the main switch
off, secul€
with a
padlock
and take
possession
of the
key.
The operator
must onsure that hands
and fingers
are kept
away from
the danger zone
of the upper
cheek and the rails
while the machine is running.
The operator
must ensure that he
is out
of
the danger
area of
the swinging
bending cheek before
stading the
bending
cheek.
CAUTION!
The bending
cheek swings
forwards by
approx. 32 inches.
The operator
must ensure that hands
and fingers are
out of
the danger
zone when the rear stop
is in motion.
Hands and
fingers
must be kept away from
the
area under the upper
cheek as the blades of the rear
stop move
forwards into the
gaps
in the
lower cheek. Risk
of injury
to hand and fingers.
The
operator must
never leave the
machine
if it has not baen
disconnected from the
electric system,
The main
switch on
the
switchgear
cabinet must
be turned
off
(position
0) and secured with
a
padlock.
Furthermore,
the
operator must take
possession
of the
padlock
key.
ATTENTION!
The machine
must not
be used
when it is due
for servicing.
The operator
must
look out for any
accidental hazards
which
may occur.
ATTENTION!
The
user must
ensure that the working
area at
and around
the
machine
is kept
clean and
tidy by means
of appropriate
instructions
and checks.
RAS 74.20-40
MULTIBEND 9OOO
19.
20
21
22.
23.
24.
25.
26.
September 7, 1993
2-9