Steps of Wheel Installation: Set the wheel into the iron shaft straight until you hear a "click"
sound and unable to pull the wheel back. It means the wheels
are successfully installed. If you want to dismantle the wheel,
pressing the wheel cover to remove the wheel.
Put the antenna into the controllersocket.
Open the lid and put the 9V battery according
to its polarity,then dose the lid.
Rechargeable batteries are to be removed
from the toy before being charged.
Different types of batteries or new and
used batteries are not to be mixed.
Exhausted batteries are to be removed
from the toy.
Only batteries of the same or equivalent
type as recommended are to be used.
Please take out batteries in case of leakage
Batteries replaced by children should
be under adults’supervision.Please do not
swap the batteries, poles over.Short circuit
should not occur to the electrical source.
Non-rechargeable batteries are not to be
recharged.
Please fake down the battery cover according
to the indicating arrow in the picture.
Properly put two “AA” batteries into steering
wheel and then cover it.
and corrosion if long terrin storage.
Please take out batteries when it is power off.
Remote control is only applicable to
adults or under the guardiance of adults
(a safe distance is 10M).
1.Replace battery of transmitter
2.Replace battery of steering wheel
3.Notice while replacing battery
1.5V AA
1.5V AA
BATTERY
Replace battery of transmitter and steering wheel
BATTERY
SCREW
To Next Page
Loading...