Need help?Do you have a question about the Rat Rig V-CORE and is the answer not in the manual?
General| Motion System | CoreXY |
|---|---|
| Heated Bed | Yes |
| Filament Diameter | 1.75mm |
| Nozzle Diameter | 0.4mm (standard) |
| Frame Material | Aluminum |
| Layer Height | 0.05mm - 0.3mm |
| Bed Leveling | Automatic Bed Leveling (ABL) supported |
Specifies the lengths of 2040 and 2020 aluminum extrusions for the V-Core frame.
Details the assembly of frame corners using M5 screws and T-nuts.
Provides a visual overview of the Z frame structure and key dimensions.
Illustrates the Z frame plates and wheel mounting components with fasteners.
Shows the assembly of front corner brackets for the Z frame.
Details the components and assembly process for the X frame.
Illustrates the mounting of Z rails and related fasteners.
Details the mounting of XY motors and associated plates.
Shows the assembly of the XY belt idler stack with components.
Illustrates the assembly of XY idler components and hardware.
Details the mounting of Z motors and lead screws.
Explains the installation of anti-backlash nuts for lead screws.
Shows different Openbuilds wheels and idlers used in the system.
Illustrates the assembly of X idler wheel stacks.
Details the X rail wheel and plate assembly.
Shows the assembly of the X carriage with its components.
Details the components for the extruder body assembly.
Shows the final assembly of the extruder unit.
To Next Page