Page 5
Connector Description
Note: To access dipswitches and connectors, open the Cellular Gateway case by unfastening the front screw using
a Phillips screwdriver and removing the lid.
Note: Connect to RS232 (J10) or CANBUS (J8) to use as a data pass through.
J2 - External Antenna- Connect the provided external antenna to the J2 connector. Only antennas approved by
RATH
®
should be used or the Cellular Gateway may not function properly and may be damaged.
DESCRIPTION
J2 EXTERNAL ANTENNA
J3 BATTERY
J6 POWER SUPPLY
J8 CANBUS
J9/J1A PHONE LINE
J10 RS232 CONNECTOR
J3 - BATTERY
J6 - POWER SUPPLY
J9 / J1A - PHONE LINE (SLIC)
Supply Voltage: 100-240vac, 60/60 Hz
PIN FUNCTION SIGNAL
1 +12 POSITIVE
2 GND NEGATIVE
PIN FUNCTION SIGNAL
1 L LIVE
3 N NEUTRAL
PIN FUNCTION SIGNAL
1 L1 TIP
2 L2 RING
To Next Page
Loading...