·
19
·
6. STARTING THE ENGINE
Recoil Starter
(1) Remove all the loads from the output side.
(2) Turn the fuel valve to the “ON” position.
(3) Turn the AC circuit breaker to the“OFF” position.
(4) Turn the choke lever to the“CLOSE” position.
Don’t close the choke when starting the engine in a warm state
(5) Turn the generator switch to the “ON” position.
(6) Pull the starter grip until a resistance is felt, then pull it out briskly.
(7) Turn the choke lever to the“OPEN” position after the engine is warm.
(8) Don’t use electric apparatus before setting circuit breaker to the“ON”
position.
Turn the generator switch to electric starting position and hold for
not longer than 5 seconds, or damage will be caused to the starting
motor. If starting fails, release the switch and wait for 10 seconds
before operating it again.
If the speed of the starting motor drops fast after running for a
period of time, it means the battery should be recharged.
STARTING THE ENGINE
To Next Page
Loading...
Need help?
General
