AXIS H-EMC/ AXIS H-EMC + W
Implement ECU software update as of
SW 2.08.00
Rauch Landmaschinenfabrik GmbH
+49 (0)7221/985-250 service@rauch.de
Page
5
of
16
Update SW
2.08.00
27/08/14
Chapter 410
4.3 Prepare the software transmission:
Connect the update cable to the PG and PC update interface
4.4 Start the software transmission:
Request: “Switch on the device in the Bootstrap condition“
Switch on the ISOBUS terminal
If the display does not change, disconnect the ISOBUS connector and plug it in
again (=> implement ECU is switched off and restarts)
The software is transmitted => Transmission of the application
start
To Next Page
Loading...
