AXIS H-EMC/ AXIS H-EMC + W
Implement ECU software update as of
SW 3.00.00
Rauch Landmaschinenfabrik GmbH
+49 (0)7221/985-250 service@rauch.de
Page
7
of
16
Update SW
3.00.00
27/08/14
Chapter 411
5. Loading the operating language and the softkey settings
If the ISOBUS terminal is started after an update, the language packages and the softkey
settings still need to be loaded.
5.1 Prepare the software transmission:
Re-connect the update cable
5.1.1 Open the Teejet File Loader
The program establishes a connection to the implement ECU
• The connection to the implement ECU is established when the transmission buttons
are highlighted
In the right-hand program field, the available files are displayed
In the left-hand program field, the data currently present on the implement ECU is
displayed
Files on the implement
ECU of the spreader
Files available for
the update
(see chapter 5.2)
To Next Page
Loading...
