AXIS H-EMC/ AXIS H-EMC + W
Implement ECU software update as of
SW 3.00.00
Rauch Landmaschinenfabrik GmbH
+49 (0)7221/985-250 service@rauch.de
Page
11
of
16
Update SW
3.00.00
27/08/14
Chapter 411
! Delete the object pool
Disconnect the ISOBUS connector and
plug it in again
As of software 3.00.00: Do not
disconnect the connector; wait until the
spreader is reloaded.
The spreader is loaded with a new object pool.
If the spreader is not loaded automatically,
restart the terminal after approx. 20 seconds
(Note: The object pool may partially be deleted
directly in the terminal)
• In the terminal menu, the transmitted languages may now be activated.
6. After the update:
After the update, the settings and the configuration are to be checked first
=> please also
refer to chapter 3 “Preparation”
Machine options:
To Next Page
Loading...
