AXIS H-EMC/ AXIS H-EMC + W
Implement ECU software update as of
SW 3.00.00
Rauch Landmaschinenfabrik GmbH
+49 (0)7221/985-250 service@rauch.de
Page
15
of
16
Update SW
3.00.00
27/08/14
Chapter 411
Weigh cells
Menu => System/test => Service => code 3354
Page 1
Calibrate scales
Check the calibration values and overwrite them if
applicable.
If the weighing display is incorrect, the weigh cells are to
be re-calibrated
Fertiliser settings:
Re-enter the fertiliser chart in the fertiliser
settings menu, check the settings
To Next Page
Loading...
