Rauch AXIS-H 30.1 EMC+W - Page 66

AXIS-H EMC/AXIS-H EMC+W
Metering slide actuator calibration
RAUCH Landmaschinenfabrik GmbH D-76547 Sinzheim
Customer service hotline: +49 (0)7221 985 250
E-mail: service@rauch.de
Page 3
of 5
27.10.2014
Chapter 420
Position
-
1
is not shown on the scale. It is
slightly under position 0. Check to ensure
that the metering slide is closed completely.
If position -1 is calibrated too far below
position 0, the slide may already open
again. Additionally, the actuator might be at
the end stop. The Rauch logo may be used
as point of reference.
Repeat this process for the
left
-
hand
side.