AXIS-H EMC/AXIS-H EMC+W
Initialisation of the drop point actuators
Rauch Landmaschinenfabrik GmbH
+49 (0)7221/985-250 service@rauch.de
Page
3
of
3 AGP-Init_de 29/08/2014
Chapter 430
Delete addresses
Disconnect the plugs of the two actuators.
Then, start address claiming
Connect the actuator plug for the right-hand side
The actuator for controlling the right-hand side is
mounted on the spreader on the left-hand side in
the direction of travel
Connect the actuator plug for the left-hand side
Initialisation successful
After the initialisation, the drop point actuators are to be calibrated
To Next Page
Loading...
