To Next PageTo Next Page
Need help?Do you have a question about the Ravaglioli RAV Series and is the answer not in the manual?
General| Brand | Ravaglioli |
|---|---|
| Model | RAV Series |
| Category | Lifting Systems |
| Language | English |
Details potential risks and protective measures for safe operation.
Main switch that can be locked for safety.
Operative system stopping movement upon release.
Mechanical stops triggered by limit switch failure.
Device resetting carriage alignment automatically.
Signals lift being stuck, preventing all movement.
Procedures for moving platforms during emergencies.
Stops lift operation due to nut wear.
Stops lift operation due to an obstacle.
Automatically resets carriage alignment when fully lowered.
Explains pictograms and their replacement if damaged.
Instructions for unpacking, handling, and initial setup of the lift.
Key technical features like movable posts, carriage translation, base, brake.
Discusses product testing and compliance with directives.
Details floor specifications like thickness, reinforcement, and load capacity.
How to check and potentially change the lift's operating voltage.
Instructions for connecting the lift to the electrical mains.
Specifications and first installation procedure for the power cable.
Explains the synchronization control device and its indicator LEDs.
Procedure for manual synchronization of platform heights.
Lists prohibited uses and situations for the lift.
Details safety checks and operator requirements before and during operation.
Describes the main post controls and their functions.
Steps for completing and checking lift operation, including alignment.
Instructions on how to dismantle the machine for relocation or disposal.
How to position the columns correctly for lifting a fork-lift truck.
Describes the use of optional support posts for stabilization.
Emergency procedures for lowering the lift during block or power failure.
Instructions for lubricating the slideways of the sliding shoes.
Procedure for topping up the lubrication tank.
Checking and replacing the main nuts based on wear.
Instructions for greasing the bearings in the columns.
Checking and adjusting drive belt tension.
Cleaning and testing safety devices for correct operation.
Checking the tightening of column retaining screws.
Procedures for making the machine inoperative and disposing of it.
Diagram of the main electrical panel and its components.
List of checks to be performed by the installer during installation.
Checklist for periodic maintenance and inspection operations.
