Function selector
THERMOSTAT CONTROL (option)
The device features a thermostat.The thermostat knob can be used to set the desired temperature. When the
temperature is high enough, the device is turned off. When the temperature drops below the set point, the fan
heater is turned on.
Setting the desired temperature
After switching the device on, set the thermostat knob to the maximum position (maximum temperature).
After the temperature reaches a satisfactory level (thermal comfort) slowly turn the thermostat knob lowering
the temperature setting until the fan heater is turned off. Keep the knob in this position. When the
temperature drops, the device is turned on and emits heat until the set temperature is reached.
Thermostat knob
Maximum temperature Minimum temperature
OVERHEATING PROTECTION
This device is equipped with fuse preventing overheating.
WARNING!
In the event that the thermal fuse is automatically engaged and the device is turned off due to the danger of
overheating, it is necessary to disconnect the power cord from power source and to wait approx. 15 minutes
until the device cools down. Only then will it be possible to turn it on again.
NOTE!
If you are not able to reach the desired temperature in room, it is necessary to use next device.
DO NOT:
• Install the device near furniture, curtains, below shelves, inside walls.
• Cover the device when it is turned on
FAILURES
If any damage is disclosed after purchase, contact the seller.
Follow the rules in this manual.
Do not modify the product.
When the device does not work, unplug it. Check if there is power in the socket the device is connected to.
If power was not disrupted, do not attempt to repair the device on your own. Contact manufacturer's
authorized service centre.
- OFF
- Cool air
I - Hot air (1000 W)
II - Hot air (2000 W)
To Next Page
Loading...
