Instruction Manual
Talking Button Clock
Model: TDC090
Please read the instructions carefully and keep for future reference
The clock is housed in a disc shaped case 8.8cm (3.5 inches) diameter by
3cm (1.2 inches) high.
Getting started
Inserting the batteries
• Only use two AAA (1.5V) alkaline batteries in this clock.
• Turn the clock over so the base is facing upwards and locate the
battery cover.
• Locate the finger tip catch on the long side of the battery cover. Using
your finger tip gently pull the clip and lift the cover away from the body
of the clock.
• Insert each battery noting the correct polarity, with the negative (flat)
end of each battery positioned against the spring.
• Once both batteries are inserted re-attach the battery cover ensuring
that the two locating lugs sit into the bottom edge of the battery
compartment.
• Close the cover, you will know when it’s properly located as you will
hear an audible click confirming the cover is correctly fitted.
To Next Page
Need help?
General
