RG55T-R Operation • Service • Maintenance
26
Operation
Remote Time Out
If the remote becomes unlinked from the machine for more
than two minutes the machine will shut down and need to
be re linked via the startup procedure
Replacing the Batteries
Should your remote batteries fail, they are replaceable.
The remote requires three AA batteries that are accessible
from the bottom of the remote. When replacing the remote
batteries Rayco recommends that you use good quality
alkaline batteries only.
To remove the batteries, locate the thumb screw (E) and
loosen to remove cover. Push the battery pack toward the
red cover (F.) and lift. Once the battery pack is removed,
slide the end with the terminals from the housing. Replace
batteries following the + and - ends and reinstall battery pack.
Emergency Stop
Should the need arise to stop the machine abruptly, the
operator can stop the machine two ways.
1. Push in on the machine Emergency Stop Switch (e) on
the machine Dash.
2. Push down on the Emergency On/Off Switch (5) on
the remote
Note: If the machine is shut down using one of the
emergency stop systems the remote may need to
be re-linked to the machine by following the start up
procedure. To reset the Machine Emergency Stop Switch
(e), turn clockwise and release.
Cutter Wheel Engagement
To engage the cutter wheel , the operator must depress
Mandatory Action Switch (6) and the Cutter Wheel switch
(4) at the same time. To turn off the cutter wheel, simply
tun the switch off.
The cutter wheel on the RG55T-R has preset parameters to
engage and disengage to extend the life of the clutch. If the
engine RPM’s are too high the cutter wheel will not engage.
Always engage the cutter wheel with the engine at idle, and
then increase engine speed.
Note: the cutter wheel parameters are intended to extend
the life of the machine and do not replace the need for
proper attire or safety equipment. Always keep a safe
distance from the cutter wheel whenever the machine
is running.
Command Cut
The Command Cut® adjustment is located on the remote
(10). The operator can select the speed of the boom swing
to optimize power and performance of the RG55T-R. 100
is full swing and 0 is slow swing.
F
E
To Next Page
Loading...
Need help?
General
