RG55T-R Operation • Service • Maintenance
800.392.2686
39
Engine Oil Level
To access the engine oil fill cap and dipstick (1), remove the
cover on top of the engine enclosure near the radiator cap.
The engine oil cap (2) will be available after the cover is
removed from the top of the engine enclosure.
Place a container to catch the used oil in the left hand side
of the machine.
Locate the engine oil drain hose on the left hand side of
the machine just above the swing cylinder. Loosen the cap
(3) on the end of the drain line to drain the oil. Be sure to
tighten the cap securely back onto the drain line before filling
engine with new oil.
Engine Oil Filter -
Remove the oil filter (4) with a filter wrench. When installing
a new filter, apply a slight coat of oil onto the gasket of the
new filter. Screw the new filter in by hand. Do not overtighten
the filter, this could cause deformation of the rubber gasket.
After the new filter has been successfully installed and
ensured that there are not any leaks. Check the oil level on
the dipstick, fill oil to the specified level.
More information and instructions can be found in your Kubota
Engine Operator Manual.
Maintenance
NOTICE
Check only when the engine is in a level position.
1
2
3
NOTICE
Use the proper SAE engine oil according to ambient
temperatures.
NOTICE
If using an oil from a different maker, or different
viscosity is needed, be sure to drain old oil
completely. Do Not mix two different types of oil.
BE SURE TO SHUT DOWN THE MACHINE, AND
ENGINE BEFORE CHANGING ENGINE OIL
AND/OR FILTER.
4
To Next Page
Loading...
Need help?
General
