Raymarine 45 STV User Manual (English)

Questions and Answers:

S
sherrydonovanAug 17, 2025
What to do if my Raymarine Satellite TV System will not find satellite?
- C
  collinskennethAug 17, 2025
  If your Raymarine Satellite TV System won't find a satellite, start by checking the in-line quick blow fuse (if fitted) to ensure it hasn't blown, and verify the circuit breaker hasn't tripped; replace the fuse with an identical one if necessary. Also, inspect the system wiring and connections. Ensure your antenna is properly installed, and if using multiple IRDs, confirm you're using an ACTIVE, not a PASSIVE, multi-switch.
B
Benjamin ZhangAug 20, 2025
Why is my Raymarine 45 STV showing a ‘snowy’ television picture?
- S
  spencer00Aug 20, 2025
  If you're experiencing a 'snowy' television picture with your Raymarine Satellite TV System, begin by checking all connections to ensure they are secure, as loose RF connectors can reduce signal quality. Verify that the IRD's configuration is correctly programmed for your current operating area. Try unplugging the IRD from the power supply for 15 seconds, then reconnect it and allow the system to initialize. If the issue persists, you might have an LNB fault, which may require replacement.
A
amoodyAug 23, 2025
What to do if there is no picture on TV set from Raymarine 45 STV?
- L
  Lauren PearsonAug 23, 2025
  If you are not getting a picture on your TV set with the Raymarine Satellite TV System, you should first check the in-line quick blow fuse (if fitted) and the circuit breaker, replacing the fuse if needed with one of the same type and rating. Next, if you've extended the power cable from the antenna unit, ensure there is no power loss. Finally, check all system wiring and connections to make sure everything is properly connected.
J
jonathanmclaughlinAug 26, 2025
How to troubleshoot Raymarine Satellite TV System antenna not functioning?
- D
  Dana RileyAug 26, 2025
  If your Raymarine Satellite TV System antenna is not functioning, first check the in-line quick blow fuse (if fitted) to see if it has blown, or if the circuit breaker has tripped, and replace the fuse with one of the same type and rating if necessary. If you've extended the power cable from the antenna unit, verify that there is no power loss. Also, inspect the system wiring and connections to ensure they are properly connected.
M
Michael RasmussenAug 28, 2025
Why does my Raymarine 45 STV work at the dock but not underway?
- J
  Jonathan DavisAug 28, 2025
  If your Raymarine Satellite TV System works at the dock but not underway, it might be due to obstructions blocking or degrading satellite signals. Ensure the antenna has a clear view of the sky, free from buildings, other boats, or equipment on your boat. Also, signal quality can degrade as you approach the edges of the antenna coverage area.
N
nelsonstephanieAug 31, 2025
What to do if Raymarine Satellite TV System has intermittent picture for short intervals?
- M
  Margaret SimmonsAug 31, 2025
  If your Raymarine Satellite TV System is showing an intermittent picture for short intervals, it could be due to satellite signals being blocked or degraded by obstructions such as buildings, other boats, or equipment on your boat; ensure the antenna has a clear view of the sky. Also, signal quality may degrade as you approach the edges of the antenna coverage area. Ensure that your antenna is installed correctly with regards to your radar unit.
S
Sara AdamsSep 3, 2025
Why is there no picture on my Raymarine Satellite TV System?
- N
  nbrooksSep 3, 2025
  If you're not getting a picture on your TV set with your Raymarine Satellite TV System, start by checking the in-line quick blow fuse (if fitted) to ensure it hasn't blown, and verify that the circuit breaker hasn't tripped. Replace the fuse with one of the same type and rating if necessary. Also, if you've extended the power cable from the antenna unit, make sure there's no power loss. Finally, check all system wiring and connections to ensure everything is properly connected.
J
Joyce RodriguezSep 5, 2025
What to do if Raymarine Satellite TV System will not find satellite?
- D
  Daniel DanielSep 6, 2025
  If your Raymarine Satellite TV System isn't finding a satellite, begin by inspecting the in-line quick blow fuse (if fitted) to see if it has blown, and check the circuit breaker to ensure it hasn't tripped. Replace the fuse with an identical one if needed. Also, if you have lengthened the power cable from the antenna unit, check for any power loss. Lastly, examine the system wiring and connections.
S
Sarah ClarkSep 8, 2025
How to fix Raymarine Satellite TV System antenna not functioning?
- J
  Jennifer PerezSep 8, 2025
  If your Raymarine Satellite TV System antenna isn't functioning or shows an ‘ANT OUT OF CONTROL’ message, first check the in-line quick blow fuse (if fitted) to see if it has blown, or if the circuit breaker has tripped. Replace the fuse with one of the same type and rating. If you've extended the power cable from the antenna unit, ensure there's no power loss. Also, check the system wiring and connections.
T
tateadamSep 12, 2025
What to do if Raymarine Satellite TV System picture is intermittent?
- A
  Amy RussellSep 12, 2025
  If you are experiencing an intermittent picture with your Raymarine Satellite TV System, you should: 1. Check the in-line quick blow fuse (if fitted) has not blown, or the circuit breaker has not tripped. Replace the fuse with one of the same type and rating. 2. If you have extended the power cable from the antenna unit, check that there is no power loss. 3. Check the system wiring and connections.

Raymarine 45 STV Specifications

General

Type	Satellite TV Antenna
Antenna Size	45 cm
Antenna Diameter	45 cm
Polarization	Linear
Frequency Band	Ku-band
Power Supply	12-24 VDC
Compatibility	DVB-S2
Elevation Range	0° to 90°
Azimuth Range	360° Continuous